	Article Directory		Article Submission Service		Article Marketing Blog		Publishers		Member Log In

Article Directory :: Reference & Education Articles

How Does Tidal Power Work?

By Denise Palmer

Republish: EasyPublish™
Published: 28Jun2007
Word count: 632
Viewed: 305 time(s)

Get Free Content For Your Site

Tidal power traditionally involves erecting a dam across the opening to a tidal basin. The dam includes a sluice that is opened to allow the tide to flow into the basin; the sluice is then closed, and as the sea level drops, traditional hydropower technologies can be used to generate electricity from the elevated water in the basin. Some researchers are also trying to extract energy directly from tidal flow streams.

There are three basic ways to tap the ocean for its energy. We can use the ocean's waves, we can use the ocean's high and low tides, or we can use temperature differences in the water.

1. Wave Energy

Kinetic energy (movement) exists in the moving waves of the ocean. That energy can be used to power a turbine. In this simple example, the wave rises into a chamber. The rising water forces the air out of the chamber. The moving air spins a turbine which can turn a generator. When the wave goes down, air flows through the turbine and back into the chamber through doors that are normally closed.

This is only one type of wave energy system. Others actually use the up and down motion of the wave to power a piston that moves up and down inside a cylinder. That piston can also turn a generator. Most wave-energy systems are very small. But, they can be used to power a warning buoy or a small light house.

For more information see: Ocean Energy Potential

2. Tidal Energy

Another form of ocean energy is called tidal energy. When tides comes into the shore, they can be trapped in reservoirs behind dams. Then when the tide drops, the water behind the dam can be let out just like in a regular hydroelectric power plant. In order for this to work well, you need large increases in tides. An increase of at least 16 feet between low tide to high tide is needed. There are only a few places where this tide change occurs around the earth. Some power plants are already operating using this idea. One plant in France makes enough energy from tides to power 240,000 homes.

3. Ocean Thermal Energy

The final ocean energy idea uses temperature differences in the ocean. If you ever went swimming in the ocean and dove deep below the surface, you would have noticed that the water gets colder the deeper you go. It's warmer on the surface because sunlight warms the water. But below the surface, the ocean gets very cold. That's why scuba divers wear wet suits when they dive down deep. Their wet suits trapped their body heat to keep them warm.

Power plants can be built that use this difference in temperature to make energy. A difference of at least 38 degrees Fahrenheit is needed between the warmer surface water and the colder deep ocean water. Using this type of energy source is called Ocean Thermal Energy Conversion or OTEC. It is being used in both Japan and in Hawaii in some demonstration projects.

Some of the oldest ocean energy technologies use tidal power. All coastal areas consistently experience two high and two low tides over a period of slightly greater than 24 hours. For those tidal differences to be harnessed into electricity, the difference between high and low tides must be at least five meters, or more than 16 feet. There are only about 40 sites on the Earth with tidal ranges of this magnitude. If there is one thing we can safely predict and be sure of on this planet, it is the coming and going of the tide. This gives this form of renewable energy a distinct advantage over other sources that are not as predictable and reliable, such as wind or solar.

To read more about this topic, see the report by Energy Business Reports titled: "Ocean Energy Potential"

EasyPublish™ this article - publishers click here